Xtium-CLHS PX4 Board Driver

The Xtium-CLHS PX4 Board driver enables Windows to communicate with Teledyne Dalsa’s Camera Link HS frame grabber, helping compatible imaging software acquire data from connected cameras. It is intended for users setting up or maintaining machine-vision systems, industrial inspection equipment, and other camera-based applications that use this board.

Choosing the right package matters: match the driver to your Windows edition, system architecture, and imaging software requirements. The supported operating systems listed for this device are Windows 10, 8.1, 7, Vista, and XP, although individual driver releases may support only a subset. For Windows 10/11 systems, check compatibility carefully—Windows 11 support is not confirmed by this listing.

Key Features

• Board communication: Provides the software interface Windows needs to recognize and work with the Xtium-CLHS PX4 Board.
• Camera acquisition support: Enables compatible applications to access image data through the board’s Camera Link HS connection.
• Imaging software integration: Supports communication between the hardware and compatible Teledyne Dalsa acquisition software, subject to package requirements.
• System maintenance: A compatible update may address known driver issues or improve reliability; consult the release notes for specific changes.

How to Install Xtium-CLHS PX4 Board Driver

1. Check your configuration. Confirm the board model, Windows version, and whether your operating system is 32-bit or 64-bit. Review any prerequisites for your acquisition software.
2. Select a compatible package. When choosing an Xtium-CLHS PX4 Board driver download for Windows, prioritize explicit compatibility over simply selecting the latest version. If a free download is offered, verify its source and publisher before running it.
3. Prepare the computer. Close camera and imaging applications. Follow the package instructions regarding existing drivers, required software components, and whether hardware installation should occur before or after driver setup.
4. Install the driver. Run the installer with administrator permissions and follow its prompts. Restart Windows if requested.
5. Verify operation. Check Device Manager for hardware warnings, then use compatible acquisition software to confirm that the board and connected camera operate correctly.

Keep the driver updated when a compatible release offers relevant fixes or supports changes to your imaging setup. Before you update a working system, review the release notes and retain the previous installer so you have a recovery option if needed.

Common Issues and Fixes

• Install fails or rolls back: Run the Teledyne DALSA installer as administrator, close antivirus, and remove previous Sapera LT/Xtium packages before reinstalling. Match the Xtium-CLHS PX4 driver to the installed Sapera LT release.
• Board not detected: Power off, reseat the PCIe card in a supported slot, confirm it appears in Device Manager, and install the Xtium driver if Windows shows an unknown PCIe device. If present but no camera link initializes, check the Camera Link HS cabling and connectors.
• Version conflicts: Cleanly uninstall old DALSA drivers and Sapera LT, reboot, then install the validated driver/Sapera LT/firmware combination for the PX4. Avoid mixing packages from different releases.