Parrot MKi9200 (Remote Control) Driver

The Parrot MKi9200 (Remote Control) driver helps Windows identify and communicate with the remote-control device entry associated with your Parrot hands-free system. It is intended for users who see this device listed in Device Manager with a missing-driver warning or need to reinstall its Windows driver after a system change.

Key Features

• Device identification: Helps Windows recognize the Parrot MKi9200 (Remote Control) entry rather than leaving it listed as an unknown device.
• Windows driver support: Listed operating systems include Windows 10, 8.1, 7, Vista, and XP. Choose a package that matches your Windows version and system architecture.
• Driver repair and replacement: Installing a matching package may resolve missing or damaged driver files. It will not necessarily fix remote pairing, battery, or in-car hardware problems.
• Compatibility checks: The vendor is listed as Csr Plc and the category as Other. Compare the package’s supported hardware IDs with those shown in Device Manager before installation.

How to Install Parrot MKi9200 (Remote Control) Driver

1. Check your system. Confirm your Windows edition and whether it is 32-bit or 64-bit. For Windows 10/11 systems, note that Windows 10 is listed as supported, but Windows 11 compatibility is not confirmed.
2. Verify the device entry. Open Device Manager, locate the relevant device, and select Properties > Details > Hardware Ids. Use these IDs to check that the driver package matches your hardware.
3. Choose a suitable package. Before starting a Parrot MKi9200 (Remote Control) driver download for Windows, review the supported systems and publisher information. If a free download is offered, verify its source and digital signature rather than relying on that label alone.
4. Install the driver. Extract the downloaded archive if necessary. Run the supplied installer, or select Update driver in Device Manager and browse to the extracted driver folder.
5. Confirm the result. Restart Windows if prompted, then check Device Manager for remaining warnings. If installation fails, recheck compatibility instead of forcing an unrelated driver.

Keep the driver updated when a verified, compatible release addresses a problem you encounter. The latest version is not always suitable for older Windows editions, so review compatibility before every update. A Windows driver update is separate from updating the Parrot system’s firmware and should not be treated as a replacement for that process.

Common Issues and Fixes

• Install fails or rolls back: Run the CSR/Parrot installer as administrator, close other Bluetooth utilities, and temporarily disable antivirus. If setup still fails, uninstall any previous Parrot MKi9200/CSR package, reboot, then retry.
• Remote not detected: Power the MKi9200 car kit, enable Bluetooth on the PC, and put the remote in pairing mode (hold its button until the LED flashes). Remove any stale “Parrot MKi9200” or CSR HID entry, then pair again.
• Version conflicts: Do not mix CSR Harmony/BlueSoleil with the Windows Bluetooth stack. Remove old CSR/Parrot drivers in Programs and Device Manager, reboot, and install one matching package only.