Brother MFC-3360C USB Remote Setup Port (COM4) Driver

The Brother MFC-3360C USB Remote Setup Port (COM4) driver helps Windows recognize the USB communication port used by Brother’s Remote Setup software to configure the MFC-3360C multifunction device. It is intended for users setting up the device over USB or troubleshooting an unrecognized remote setup port in Device Manager. Although some driver listings place this component in the Camera category, it is a configuration interface rather than a camera driver.

Key Features

• Remote Setup communication: Supports the connection between compatible Brother configuration software and the MFC-3360C over USB.
• Port recognition: Helps Windows identify the remote setup interface, which may appear as COM4. The assigned COM number can vary between computers.
• Legacy Windows support: Intended for use with a matching package for Windows 10, 8.1, 7, Vista, or XP; check the individual download’s compatibility before installation.
• Component-specific support: Addresses the remote setup port, not every printer or scanner function. Additional Brother drivers or utilities may be required for full device operation.

How to Install Brother MFC-3360C USB Remote Setup Port (COM4) Driver

1. Check your Windows version. Confirm your operating system and whether it uses a 32-bit or 64-bit architecture. When comparing Windows 10/11 options, note that Windows 11 is not included in the supported OS list provided for this device.
2. Choose a compatible package. Before starting your Brother MFC-3360C USB Remote Setup Port (COM4) driver download for Windows, verify the model, operating system, and package contents. Select the latest version available for your specific configuration, not simply the newest-looking listing.
3. Download from a trusted source. Prefer Brother’s official support resources where available. A free download should not require purchasing a third-party driver updater.
4. Install the driver. Extract the package if necessary, run its installer, and follow the prompts. Connect or disconnect the USB cable only as instructed. If the package contains no installer, follow its included manual installation guidance.
5. Verify the connection. Restart Windows if requested, then check Device Manager for warning icons. If compatible Brother Remote Setup software is installed, open it and confirm that it can communicate with the device.

Keep this driver updated when a compatible release addresses a connection problem or supports your Windows configuration. Before you update, review the package notes and retain a copy of the working installer so you can restore it if needed.

Common Issues and Fixes

• Install fails or rolls back: Run the Brother MFC-3360C setup as administrator and use the original driver package for your Windows version. Disconnect other Brother USB devices during install, then reboot before retrying.
• Device not detected / COM4 missing: Connect the MFC-3360C directly to a rear USB port, not a hub. Power-cycle the printer, check Device Manager for “Brother MFC-3360C USB Remote Setup Port,” and reinstall if the COM port does not appear.
• COM port or driver version conflict: Remove older Brother software and hidden USB Remote Setup entries in Device Manager, reboot, then install the current package. If COM4 is already used, reassign the Remote Setup port to a free COM number.