The Digi AnywhereUSB Host Controller driver from Digi International enables Windows to communicate with USB devices connected through a compatible AnywhereUSB network hub. Rather than requiring a direct USB connection to the PC, this setup allows supported peripherals—including compatible USB printers—to be accessed over a network.

Key Features

• USB connectivity over a network: Provides the Windows-side components needed to communicate with a compatible Digi AnywhereUSB hub and its attached USB devices.
• Support for remote peripherals: Helps applications access supported USB equipment located away from the computer, which can be useful in shared offices or centralized equipment installations.
• Windows driver integration: Allows the AnywhereUSB host controller to operate within Windows. Select a driver release that explicitly supports your hub model and Windows 11, 10, 8, or 7 installation.
• Works alongside peripheral drivers: Supplies the AnywhereUSB connection layer; an attached printer or other USB device may still require its own manufacturer-provided driver.

How to Install

1. Check your hardware and Windows version. Identify the exact AnywhereUSB hub model and confirm your Windows edition and system architecture. Review the package’s compatibility information, since support can vary between hub generations and driver releases.

1. Download the appropriate Digi package. Choose the Digi AnywhereUSB Host Controller driver or software package intended for your hardware and operating system. Extract the download first if it arrives as a compressed archive.

1. Run the installer with administrator permissions. Follow the setup prompts to install the required components. If an older Digi installation is present, follow the package instructions for upgrading or removing it, and restart Windows if requested.

1. Connect and configure the AnywhereUSB hub. Ensure the hub is powered on and reachable from the PC over the network. Use the Digi configuration or management utility supplied for your model to locate the hub and establish the connection, following its documentation.

1. Install and test the attached device. Connect your supported USB peripheral to the hub and install its separate driver if needed. Check Device Manager for errors; for a printer, print a test page to confirm communication.

If Windows does not detect the attached device, check network access, the hub’s connection status, and any firewall requirements described in Digi’s documentation before reinstalling the driver.

Common Issues and Fixes

• Install fails or rolls back: Run the Digi installer as administrator, confirm Windows version/architecture matches the driver, and remove any older AnywhereUSB package via Apps & Features. Reboot before retrying and check Device Manager for blocked/unsigned driver warnings.
• Device not detected: Verify the AnywhereUSB unit is powered and network-reachable. Confirm the host PC and device are on a routable subnet and firewall rules allow Digi AnywhereUSB traffic. Reconnect in AnywhereUSB Manager and rescan.
• Version conflicts/unknown device: Uninstall old AnywhereUSB Host Controller drivers, show hidden devices in Device Manager, remove stale entries, then install only the latest Digi package. Avoid mixing older and newer driver versions on the same host.