The Canon imageCLASS MF4370dn driver connects this monochrome laser multifunction printer to your Windows PC, allowing applications to send print jobs with the correct settings. Installing the appropriate Canon package helps you access printing options, while scanning may require a separate scanner driver or utility.

Key Features

• Printer settings access: Configure paper size, orientation, copy count, and print quality through the Windows print dialog.
• Two-sided printing controls: Use the MF4370dn’s automatic duplex printing capability to reduce paper use for longer documents.
• USB and network connectivity: Set up printing through a direct USB connection or access the printer over its Ethernet network connection.
• Scanning support: With compatible scanner software installed, transfer paper documents to your computer for saving or sharing.

How to Install

1. Check your Windows version. Identify whether your PC runs Windows 11, 10, 8, or 7, and confirm whether it uses a 32-bit or 64-bit system. Choose a driver package that explicitly supports your configuration; compatibility can vary between packages.

1. Download the appropriate Canon driver. Select the package for the Canon imageCLASS MF4370dn. If you also need scanning, check whether the download includes scanner support or requires an additional utility.

1. Prepare the connection. Turn on the printer. For Ethernet setup, connect it to the same local network as your computer. For USB installation, leave the cable disconnected until the installer requests it.

1. Run the installer. Open the downloaded file, allow it to make changes if prompted, and follow the setup instructions. Select the intended connection type and choose the correct printer when it appears.

1. Confirm operation. Restart Windows if requested, then print a test page from the printer’s settings. If scanning software was installed, try scanning a document as well. If network detection fails, verify the printer’s connection and IP address before adding it manually.

Common Issues and Fixes

• Install fails or stalls: Run the Canon MF4370dn UFR II driver setup as administrator, disconnect USB until prompted, and temporarily disable antivirus. Remove any partial Canon install before retrying.
• Device not detected: For USB, use a direct rear port and a known-good cable. For network, confirm the printer has a valid IP, is on the same subnet, and responds to ping; then add it by IP.
• Version conflicts: Uninstall older Canon imageCLASS/MF drivers and MF Toolbox, restart Windows, then install the correct 32/64-bit driver for your OS. Remove duplicate printer queues.