The Behringer UMC202 Audio driver enables Windows to communicate with your USB audio interface for recording and playback. Installing the appropriate Behringer driver helps audio applications access the interface’s inputs and outputs, with settings suited to tasks such as recording vocals, capturing instruments, and monitoring a mix.

Key Features

• Audio input and output access: Allows compatible Windows software to use the UMC202 for recording connected microphones or instruments and playing audio through its outputs.
• ASIO support for recording software: Provides a dedicated audio driver option for compatible digital audio workstations, helping reduce latency compared with general-purpose Windows audio paths.
• Adjustable audio settings: Offers access to supported sample-rate and buffer settings so you can balance responsiveness against playback and recording stability.
• Windows integration: Supports use of the interface as an audio device in Windows and compatible applications. For Windows 11, 10, 8, or 7, choose a driver release that explicitly lists your operating system.

How to Install

1. Check the model and Windows version. Confirm that your interface is the Behringer UMC202, rather than a similarly named model such as the UMC202HD. Check your Windows version and system type, then select a driver package that lists both your device and operating system.
2. Download and prepare the driver. Save the compatible Behringer driver package to your computer. Extract it if supplied as a compressed archive, and close recording software or other applications using audio.
3. Run the installer. Open the setup file and approve the Windows permission prompt if requested. Follow the on-screen instructions, including any directions about when to connect or disconnect the interface.
4. Connect and configure the interface. After installation, connect the UMC202 to an available USB port and restart Windows if prompted. Select it in Windows sound settings for playback or recording as needed.
5. Set up your audio application and test. In your recording software, select the Behringer ASIO driver if available and enable the required inputs and outputs. Test playback and make a short recording; if you hear clicks or dropouts, try increasing the buffer size before recording again.

Common Issues and Fixes

• Install fails or hangs: Disconnect the UMC202, run the driver installer as administrator, and temporarily disable antivirus. Reboot before reconnecting. Avoid USB hubs and use a direct rear USB port.
• Device not detected: Try a known-good USB cable and another port. Check Device Manager for “USB Audio” or unknown devices. Close your DAW, replug the interface, and confirm the sample rate in Windows sound settings matches the ASIO control panel.
• Version conflicts/ASIO errors: Uninstall older Behringer/USB audio drivers, reboot, then install the latest package. In your DAW, select the UMC202 ASIO driver and use the same sample rate as Windows—typically 44.1, 48, or 96 kHz.