The D Link DL10028 driver allows Windows to recognize the D-Link network hardware and use it for a wired network connection. If the adapter appears as an unknown device or cannot connect after a Windows installation, installing a matching driver may restore normal operation.

Key Features

• Hardware recognition: Helps Windows identify the network adapter correctly rather than listing it as an unrecognized network controller.
• Wired networking support: Provides the software interface needed for the adapter to communicate with Windows networking services.
• Adapter configuration: Makes supported network settings available through Windows, with options depending on the hardware revision and driver package.
• Troubleshooting information: Allows you to check driver details and device status in Device Manager when investigating connection problems.

How to Install

1. Confirm the adapter’s identity. Open Device Manager and look under Network adapters or Other devices. Check the device’s Properties > Details > Hardware Ids to verify that the driver package matches your D Link DL10028 hardware.

1. Check Windows compatibility. Select a package that explicitly supports your Windows version and system architecture. For Windows 11, 10, 8, or 7, verify compatibility before installation; an older driver should not be assumed to work on a newer system.

1. Download and extract the driver. Save the matching package to your computer and extract it if it is compressed. If the PC has no network access, download the files on another computer and transfer them using a USB drive.

1. Install the package. Run the included installer, if provided, and follow its instructions. Alternatively, right-click the adapter in Device Manager, choose Update driver, select Browse my computer for drivers, and point Windows to the extracted folder.

1. Restart and test the connection. Restart if prompted, connect the Ethernet cable, and check that Device Manager shows the adapter without a warning icon. Test access to your local network or the internet. If the connection still fails, inspect the cable and router port before replacing the driver again.

Use a trusted driver source and avoid forcing installation when Windows reports that the package does not match the device. A matching hardware ID is more reliable than a similar product name when selecting a network driver.

Common Issues and Fixes

• Install fails or rolls back: Unplug the DL10028 USB Ethernet adapter, run the installer as administrator, and match the 32/64-bit driver to Windows. Temporarily disable antivirus if it blocks the signed installer.
• Device not detected: Try another USB port, preferably USB 2.0, and check Device Manager for an unknown device. Confirm the adapter LED is on; reinstall USB/chipset drivers if the port is not enumerating.
• Version conflicts or dropped links: Remove old D-Link/ASIX Ethernet drivers in Device Manager, reboot, then install the current DL10028 driver. If autonegotiation fails, set the adapter to 100 Mbps Full Duplex.