The CUSTOM VKP80II ETH driver allows Windows to communicate with your CUSTOM printer and send print jobs through the correct printing interface. For an Ethernet-connected setup, installing the appropriate driver and configuring the network port helps applications route output to the printer reliably.

Key Features

• Windows printing integration: Makes the CUSTOM VKP80II ETH available through the Windows print system so compatible applications can select it as an output device.
• Network printer configuration: Works with a properly configured Ethernet connection and printer port to direct jobs to the device’s network address.
• Print preference controls: Provides access to the options supported by the installed driver, such as paper dimensions and output layout, to help match your application’s requirements.
• Support for Windows environments: Choose the appropriate package for Windows 11, 10, 8, or 7, checking its listed compatibility and system architecture before installation.

How to Install

1. Check your system and connection. Confirm your Windows version and whether it uses a 32-bit or 64-bit architecture. Power on the printer, connect its Ethernet cable, and make sure your computer can reach it on the network.

1. Download the matching driver. Select a CUSTOM VKP80II ETH driver package that explicitly supports your operating system. Extract the downloaded archive if necessary, and review any included installation instructions.

1. Run the installer. Open the setup program with administrator permissions and follow its prompts. If the package contains driver files without an installer, use the Windows Add Printer wizard and select the supplied driver file when prompted.

1. Configure the network port. Choose the network installation option, or add the printer manually using its IP address. Use the port settings recommended in the CUSTOM documentation rather than assuming the default configuration is correct.

1. Verify printing. Open the printer’s properties and print a test page. Check the paper settings and try a sample job from your intended application. If nothing prints, confirm the printer’s IP address, connection status, and selected port before reinstalling the driver.

Common Issues and Fixes

• Install fails or stalls: Run the CUSTOM VKP80II ETH package as administrator, unblock the downloaded ZIP, and temporarily pause antivirus. Confirm you’re using the ETH driver for your Windows version, not a USB VKP80II package.
• Device not detected: Verify the printer has a valid IP on the same subnet as the PC, ping it, then add it manually as a TCP/IP printer using port 9100. Check switch cabling and Windows firewall rules for raw printing.
• Version conflicts: Remove old CUSTOM VKP80II print queues and drivers in Print Management, restart the Print Spooler, then reinstall the latest ETH driver. Avoid mixing generic thermal printer drivers with the CUSTOM package.