The Brother DCP 8080DN driver connects this multifunction laser printer to your Windows PC, allowing applications to send print jobs with the correct settings. Installing the appropriate Brother package helps you access printing controls and, when included, scanning functions rather than relying on a basic printer connection.

Key Features

• Device-specific printing controls: Adjust paper size, orientation, resolution, and other available options to suit everyday documents or longer reports.
• Automatic two-sided printing: Access the printer’s duplex settings to reduce paper use and produce neatly arranged double-sided documents.
• USB and network setup: Configure the Brother DCP 8080DN for a direct USB connection or use it over a wired Ethernet network shared with other computers.
• Scanning support: A compatible scanner driver or full software package can enable document scanning from the flatbed or automatic document feeder. Available tools depend on the package you install.

How to Install

1. Check your Windows version. Before downloading, confirm whether your computer runs Windows 11, 10, 8, or 7. Check the system architecture as well, and choose a package explicitly listed as compatible with your setup. Driver availability and installation methods can vary between Windows versions.

1. Choose the functions you need. Download the appropriate printer driver for printing, or select a compatible full driver package if you also need scanning support. Review the package description rather than assuming every download includes both functions.

1. Prepare the connection. Turn on the printer and load paper. For USB installation, leave the cable disconnected until the installer requests it, unless the package instructions say otherwise. For Ethernet, connect the printer to your router or switch and make sure your PC can reach the same network.

1. Run the installer. Open the downloaded file, extract it if necessary, and follow the setup prompts. Select the connection type and choose your Brother device when it appears. If the download contains only driver files, follow its instructions for adding the printer through Windows.

1. Verify printing and scanning. Print a test page from Windows printer settings, then check duplex and paper options. If you installed scanning components, try a sample scan. A printer that is not detected may need its connection, network address, or selected port checked before setup can finish.

Common Issues and Fixes

• Install fails or stalls: Run the Brother DCP-8080DN package as administrator, disconnect USB during driver setup if prompted, and temporarily disable antivirus. Remove any prior Brother printer entries in Devices and Printers before retrying.
• Device not detected: For USB, use a direct rear-port connection and a known-good cable; avoid hubs. For network, confirm the DCP-8080DN has a valid IP on the same subnet, ping it, and add it by IP rather than auto-discovery.
• Driver/version conflicts: Uninstall old Brother DCP-8080DN drivers and software, restart, then install the full package matching Windows version and 32/64-bit architecture. Avoid Windows Update’s generic laser driver if scanning or duplex features fail.