The Bixolon SRP 330 driver connects your receipt printer to Windows, allowing compatible point-of-sale software and other applications to send print jobs correctly. Installing the appropriate Bixolon driver helps you configure receipt printing and access the printer’s supported settings on Windows 11, 10, 8, or 7.

Key Features

• Windows printing integration: Makes the Bixolon SRP 330 available to compatible applications through the Windows printing system.
• Receipt layout settings: Provides access to supported paper sizes and print preferences so you can match output to your receipt roll and software layout.
• Connection configuration: Lets you associate the printer with the correct Windows port for the interface fitted to your unit.
• Print-job management: Works with the Windows print queue, where you can check job status, pause printing, or cancel pending receipts.

How to Install

1. Check your Windows version. Confirm whether your computer runs Windows 11, 10, 8, or 7, and check its system type. Choose a driver package that explicitly supports your operating system and the SRP 330 model.

1. Prepare the printer. Load receipt paper, close the cover, and connect the power supply. Check which interface your unit uses. For a USB connection, follow the installer’s instructions about when to connect the cable.

1. Run the driver installer. Extract the downloaded package if necessary, then launch the setup program. Allow administrator access if Windows requests it and follow the installation prompts.

1. Select the model and connection. Choose the Bixolon SRP 330 when prompted, then assign the appropriate port. If you use a network-equipped unit, confirm that its network address matches the port configuration.

1. Print and adjust a test receipt. Open the printer’s properties in Windows and print a test page. Then review the paper settings in both the driver and your point-of-sale application to prevent clipped text, unwanted margins, or excess blank space.

If the printer does not respond, check its power, cable or network connection, and selected port before reinstalling the driver. A successful Windows test print can help you distinguish a connection problem from an application-specific printing issue.

Common Issues and Fixes

• Install fails or printer shows as “Unknown device”: Disconnect the USB/serial/parallel cable, run the installer as Administrator, reboot, then reconnect. For the SRP 330, confirm the correct interface type is selected during setup.
• Device not detected: Check printer power and cable, try another USB port or known-good serial cable, and verify the port in Device Manager and Printer Properties. For serial models, set the correct COM port and baud rate.
• Version conflicts or duplicate printer queues: Remove old Bixolon/SRP drivers and duplicate SRP 330 queues, restart the print spooler, then reinstall the current Windows driver and test-print before setting it as default.