The ASIX AX88179 USB 3.0 to Gigabit Ethernet Adapter adds a wired network connection to a computer through a USB port. Its driver allows Windows to recognize the adapter and communicate with it for Ethernet access to your local network and the internet. Choose a driver package that explicitly supports your version of Windows 11, 10, 8, or 7 and matches your system architecture.

Key Features

• USB-to-Ethernet connectivity: Enables Windows to use the AX88179 adapter as a wired network interface, making it useful for computers without a built-in Ethernet port.
• Gigabit Ethernet support: Supports connections up to 1 Gbps when used with compatible network equipment and cabling. Actual throughput depends on the USB connection, network conditions, and other hardware.
• Windows network integration: Makes the adapter available through standard Windows networking tools, where you can check connection status and configure IP settings.
• Adapter configuration: Provides access to supported driver settings through Device Manager. Available options can vary by driver release and Windows version.

How to Install

1. Check your Windows version and architecture. Open your system information to confirm which Windows edition you use and whether it is 32-bit or 64-bit. Select the corresponding ASIX AX88179 driver package; a single download may not support every listed operating system.
2. Download and extract the driver. Save the compatible package to your computer. If it comes as a compressed archive, extract its contents before starting installation. If this adapter is your only internet connection, download the package on another device and transfer it using a USB drive.
3. Run the installer or use Device Manager. Follow the included setup instructions if an installer is provided. For a manual installation, connect the adapter, open Device Manager, locate it under Network adapters or Other devices, and select Update driver. Browse to the extracted driver folder.
4. Connect the network cable. Plug the adapter into a USB 3.0 port for best performance, then connect an Ethernet cable to your router or switch. Restart Windows if prompted.
5. Verify the connection. Check that the adapter appears in Device Manager without a warning icon and that Windows reports an Ethernet connection. If it does not, check the cable, try another USB port, and confirm that the installed driver matches your adapter and operating system.

Common Issues and Fixes

• Install fails or rolls back: Uninstall any existing AX88179 entry under Device Manager > Network adapters, disconnect the adapter, run the ASIX installer as administrator, reboot, then reconnect.
• Adapter not detected or drops link: Connect directly to a USB 3.0 port, avoid hubs/extension cables, and check Device Manager for unknown USB devices. Power-cycle the adapter and reinstall if needed.
• Driver version conflicts: Check Driver Provider/Version in Device Manager. If Windows uses a generic or older ASIX driver, install the latest vendor package; if a Windows Update breaks it, roll back or reinstall the ASIX driver.