Name: Numark OMNI CONTROL MIDI 2.9.13 Driver
Author: Numark

Question 1

Install fails or rolls back?

Accepted Answer

Disconnect the OMNI CONTROL before running the 2.9.13 installer, close DJ/audio apps, and run setup as administrator. Temporarily disable antivirus if it blocks the MIDI/audio driver, then reboot before reconnecting the controller.

Question 2

Device not detected?

Accepted Answer

Use a direct rear USB port rather than an unpowered hub, try a known-good USB cable, and check Device Manager for the Numark MIDI/audio device. Reinstall 2.9.13 if Windows shows an unknown device or yellow warning.

Question 3

Version conflicts?

Accepted Answer

Uninstall any older Numark OMNI CONTROL MIDI driver first, reboot, then install 2.9.13 only. Avoid letting Windows automatically replace the driver; after installation, confirm the controller appears correctly in your DJ software’s MIDI and audio settings.